ARCTIC P14 PWM case fan, 4-pin, 140mm, white

Case fan P14 PWM, 4-pin, 140mm, white.
\r\n
\r\n
\r\nFeatures: <\/b>
\r\nOptimized for static pressure<\/u>. When developing the new P14 PWM fan, special attention was paid to focused airflow and static pressure. This fan guarantees particularly efficient cooling, even with increased air resistance.
\r\nMaximum quietness, minimal vibration<\/u>. Even at low speeds, the operating sound of the new ARCTIC motor is barely noticeable. Thanks to sinusoidal magnetization, the new motor is very smooth and almost vibration-free - it generates only about 5% of the vibration level produced when a conventional unfiltered DC motor is switched on. As a result, the fans do not need to use anti-vibration pads.
\r\nMore efficient technology<\/u>. The motor is powered by a new generation PWM integrated circuit, enabling the new P14 PWM to operate more efficiently than previous models. It saves energy and reduces coil temperature without compromising performance.
\r\nHigh-quality bearing<\/u>. The combination of alloy and lubricant developed in Germany reduces friction in the bearing and provides greater efficiency. This results in less heat dissipation and reduced bearing noise, and you can enjoy a longer service life for your fan.
\r\n200-1700 rpm speed, PWM adjustable<\/u>. Thanks to the 4-pin connector, the speed can be adjusted over a wide range via PWM (pulse width modulation), meaning the fan changes speed/airflow as needed, depending on the temperature.
\r\nLong service life<\/u>. A 10°C lower motor temperature approximately doubles the fan's service life. The service life of the new ARCTIC motor is significantly longer due to the low coil temperature. Therefore, the warranty has been extended to 6 years.
\r\nTwo operating modes<\/u>. Expelling warm air from the case. Blowing cold air into the case.
\r\n
\r\n
\r\nTechnical data:<\/b>
\r\nSpeed: 200-1700 rpm.
\r\nAirflow: 72.8 CFM / 123.76 m³\/h.
\r\nStatic pressure: 2.40 (mm / H2O).
\r\nNoise level: 0.3 sone.
\r\nBearing: fluid dynamic bearing.
\r\nVoltage / current 0.12A / 12V DC.
\r\nStarting voltage: 3.9 V.
\r\nConnector: 4-pin.
\r\nCable length: 400 mm.
\r\nDimensions: 140x140x27 mm.
\r\nWeight: 194 g.
\r\nColor: white.
\r\n
\r\n
\r\nWarranty:<\/b> 6 years.<\/p>\r\n